ARKMICRO USB-UART CABLE DRIVER DOWNLOAD

Going of another thread here I suspect that the wires in the cable are as follows: Well i have a hard time cracking open the end piece, is it possible to diagnose the wires with a multi-meter and how so? Zedboard forums is currently read-only while it under goes maintenance. So just plugging it in, without the other end hooked up to anything, just means its a good cable. The post mentioned does not solve my problem. Hooked up the red cable to match up to the 3V3 pad on the router for power and twisted the blue and white just to test out the prolific drivers from the wiki. If you try doing it from the computer end of the cable, how are you going to tell which signal is which and what the values are supposed to be?

Uploader: Fauzil
Date Added: 18 December 2015
File Size: 31.25 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 27754
Price: Free* [*Free Regsitration Required]

You can google how to use a multimeter.

man uark (4): Arkmicro Technologies ARK based USB serial adapter

So just plugging it in, without the other end hooked up to anything, just means its a good cable. Cannot see new device, COM port in device manager. To test the arkmcro, you have to plug it into the USB port of the computer. All these USB to serial cables have a chip inside them. Hi Carlitos, Unfortunatly I haven’t encountered your issue in the past.

  MITA FS1010 DRIVER

So when you touch the red multimeter to 1 wire, and the black multimeter to one of the USB jack ends, you should see 0 Ohm or hear a Beep That means you have the same wire. How else can you tell which wire runs to which pin if you dont crack open the end?

Well i have a hard time cracking open the end piece, is it possible to diagnose the wires with a multi-meter and how so?

Mon Jun 13, Hooked up the power and ground to the router. Really need help for my specific problem please. The post mentioned does not solve my problem. Mon Jun 13, 0: ArkMicro Windows 7 Driver.

And no, there is no SET color coding – manufacturers choose whatever they want. Please try looking at these posts http: Going of another thread here I suspect that the wires arkjicro the cable are as follows: Display posts from previous: Installed the driver and utility from the Serial Recovery Wiki. You still have to determine what wire is what. That leaves your other line as RX. Can some one help me out here? Then compare the wire colour to the picture linked to in the wiki.

  G41MX-K 2.0 DRIVER

Ports – ArkMicro – ArkMicro USB to Serial Ports Computer Driver Updates

If there is no signal, then you arkmocro be on the RX line. I measured all the wires. Hooked up the red cable to match up to the 3V3 pad on the router for power and twisted the blue and white just to test out the prolific drivers from the wiki. Never used one before.

I know its been said you can find the ground by measuring the ohms with a multimeter set to OHM. Wrong unfortunately, the multimeter does NOT provide power. I also tried on Windows 7.

I have Win 7 x I never see any amber light flashing and no output on the console terminal. You don’t have to break open the end piece. If I try to update the drivers for such COM1 port and select Win7 drivers from Cypress installed folders then it does change the type of the port to USB serial port but still does not work.

I only see the same COM1 port that has been there before.